Sportbike Forums on WristTwisters banner
1 - 3 of 3 Posts

·
`
Joined
·
3,862 Posts
very easy:

I never did it without removing forks but I'm sure it can be done.

remove handlebars out of the way and remove front wheel axle.
undo top caps (don't worry, spring won't jump out) and slowly raise the bottom part of the fork leg so chrome slide goes into it a little. Be careful not to raise it to high or oil will leak. As you raise the leg, the cartridge rod will come up and you will see the spacer and the spring.
Remove slotted washer that sits between nut and the spacer and than take the top cap of with the wrench while holding that lower nut.

pics tell a thousand words


 

·
`
Joined
·
3,862 Posts
Thanks for the tutorial!
:hello:

btw, once you remove the spring, don't let go to the cartridge rod, tie a wire to it or something before you let it go. If you let it go, it will just sink inside and you will need to take forks out as the lower triple won't let you raise the bottom leg far enough so you could reach that rod
 

·
`
Joined
·
3,862 Posts
Still playing with preload settings, haven't touched rebound yet.
are you talking about the front?
if so, there is no need to play with stock forks as they are way out of your weight range. Crank that preload all the way in and put rebound 2.5 turns out from full in.
I wouldn't wait for the warranty and at least do the min - put 1kg springs in the front. Being 240lbs you will see a drastic difference from the stock, it will be just like new bike. It will be the best $100 you can spend on your 919.

BTW, warranty on 919, especially extended warranty is the biggest scam going IMO, they just don't brake. I've yet to see anyone with 919 who claimed a manufacturing defect
 
1 - 3 of 3 Posts
Top